The Beerbarian Malt Mill

I drilled and tapped ¹/₄" #20 thread holes in the end of the plates to attach a ¹/₈"x3"x9" aluminum plate along the longer length.

I drilled and tapped ¹/₄" #20 thread hole in the top to help secure the bearing for the dead roller in place.

Here you can see the threaded hole for the set screw that hold the eccentric in place when the gap is set.

These are the plates that run along the long length. Notice on the bottom plate there are extra holes to be able loosen or tighten the eccentrics.